|
<< Click to Display Table of Contents >> Navigation: Designing a PCB with DEX > Projects > Circuit Simulation > The Spice Reference Manual > Analysis and output Control > Transient Analysis |
General form:
.TRAN TSTEP TSTOP <TSTART; <TMAX;>>
Examples:
.TRAN 1NS 100NS .TRAN 1NS 1000NS 500NS .TRAN 10NS 1US
TSTEP is the printing or plotting increment for line-printer output. For use with the post-processor, TSTEP is the suggested computing increment. TSTOP is the final time, and TSTART is the initial time. If TSTART is omitted, it is assumed to be zero. The transient analysis always begins at time zero. In the interval <zero;, TSTART>, the circuit is analyzed (to reach a steady state), but no outputs are stored. In the interval <TSTART;, TSTOP>, the circuit is analyzed and outputs are stored. TMAX is the maximum stepsize that SPICE uses; for default, the program chooses either TSTEP or (TSTOP-TSTART)/50.0, whichever is smaller. TMAX is useful when one wishes to guarantee a computing interval which is smaller than the printer increment, TSTEP.
UIC (use initial conditions) is an optional keyword which indicates that the user does not want SPICE to solve for the quiescent operating point before beginning the transient analysis. If this keyword is specified, SPICE uses the values specified using IC=... on the various elements as the initial transient condition and proceeds with the analysis. If the .IC control line has been specified, then the node voltages on the .IC line are used to compute the initial conditions for the devices. Look at the description on the .IC control line for its interpretation when UIC is not specified.