<< Click to Display Table of Contents >> Navigation: Designing a PCB with the DEX PCB Designer > The User Interface > The Ribbon Menu > The Add Ribbon Page |
The Add Ribbon Page
Click on any below to expand.
Undo
Redo
Cancel Click on the small button at the bottom right of the command group to display the Undo Popup |
Undo/Redo Commands
Add Part
Resistor
Capacitor
Vcc
Analog Click on the small button at the bottom right of the command group to display the Add Parts Popup. |
Parts Commands
Vertical Guide
Horizontal Guide
Angled Guide
Point Guide
|
Guides Commands
Line
Polyline
Arc
Curve
Text
Image
Hollow Rectangle
Filled Rectangle
Solid Rectangle
Hollow Rounded Rectangle
Filled Rounded Rectangle
Solid Rounded Rectangle
Hollow Ellipse / Circle
Filled Ellipse / Circle
Solid Ellipse / Circle
Hollow Polygon
Filled Polygon
Solid Polygon
Hollow Closed Curve
Filled Closed Curve
Solid Closed Curve
Note
Note With Rounded Corners
Line Style
Fill Style
Line Width
Click on the small button at the bottom right of the command group to display the Shapes Default Popup. |
Graphical Shapes Commands
Ellipse
|
Markers Commands
Linear
Aligned
Coord.
Click on the small button at the bottom right of the command group to display the Dimension Settings Popup. |
Dimensions Commands
Wire
No Connect
Inter-Wire
Click on the small button at the bottom right of the command group to display the Wire and Bus Settings Popup. |
Wires Commands
Bus
Bevel
Click on the small button at the bottom right of the command group to display the Wire and Bus Settings Popup. |
Buses Commands
Border
Line
Medium
Short
Dot
Point
Circle
Dot-Clock
Clock
Input
Output
|
Symbol Commands
New
Add Existing
Port
|
Sub Commands
Create a New Schematic This adds a new schematic sheet to your project.. Create a New Symbol In parts, schematics act as symbol schematics. So, if you have a part that needs two symbols, then you would have two schematic symbol sheets. If you currently have a part open, then the additional schematic symbol sheet will be a sub-part. For instance, if you are creating a part which has 2 op-amps, you would have 2 schematics symbol sheets in total; one for each op-amp. You might also add an additional schematic symbol sheet for the power connections. Create a New Text This will add a new text/document sheet to your design.
Add a PDF to the Design Clicking this will allow you to embed an Adobe PDF file in your project/part. Add a PDF to the Design Clear Clears the current sheet. |
Sheet Commands