<< Click to Display Table of Contents >> Navigation:  Designing a PCB with DEX > Projects > Circuit Simulation > Adding Instruments > Function Generators > Connecting a Function Generator to a Circuit

To connect a function generator to wires:

1.Click on the or terminal and drag the cursor to a target wire. A new electrical wire will appear and will be auto-routed from the function generator's terminal to the position of the cursor as you move the mouse.

2.Release the left mouse button over a target wire to finish off the connection or press the ESC key to cancel.

NOTE: The colors of the red and blue wires were set by clicking on each of the wires is turn, and clicking on a color button in the Color Bar. The colors of the oscilloscope's traces reflect the color of the associated wires.